How to measure an air brake tank for a replacement
By the TRECA engineering team · Updated · 6 min read
To order a replacement air tank you need five things: the overall length head to head, the diameter (best measured as the circumference divided by 3.1416), the size and position of every coupling, the bracket spacing and the steel gauge.
What you need
- A flexible tape measure, the kind used by tailors or upholsterers.
- A rigid tape measure for the length.
- A caliper, if you want to confirm the steel thickness.
- Your phone, for the photos.
It takes about 15 minutes. If the tank is still mounted, drain the air system before touching couplings or straps.
1. Measure the overall length
Measure end to end, from the outermost point of one head to the other. Do not count the couplings or fittings that stick out of the heads. Round to the nearest quarter inch: our standard tanks run from 17 1/2 to 42 inches.
2. Measure the diameter from the circumference
Wrap the flexible tape around the tank shell, away from couplings and brackets, and divide the result by 3.1416. It is more accurate than measuring side to side with a tape measure.
| Measured circumference | Diameter |
|---|---|
| 29.85 in (758 mm) | 9 1/2 in |
| 31.42 in (798 mm) | 10 in |
| 37.70 in (958 mm) | 12 in |
| 39.47 in (1,002 mm) | 12 9/16 in |
3. Locate and size every coupling
For each coupling, note:
- Whether it is on the shell or on one of the heads.
- The distance from the nearest head to the center of the coupling.
- Its position around the tank as a clock face, looking at the tank from one head: 12 is the top and 6 the bottom, where the drain coupling usually sits.
- The thread size.
To find the size, measure the outside diameter of the thread on the fitting screwed into the coupling. Pipe thread (NPT) is the most common on air tanks:
| Coupling | Thread outside diameter |
|---|---|
| 1/4 in | 0.54 in (13.7 mm) |
| 3/8 in | 0.68 in (17.1 mm) |
| 1/2 in | 0.84 in (21.3 mm) |
| 3/4 in | 1.05 in (26.7 mm) |
4. Measure the mounting brackets
Count the brackets welded to the tank and measure the center-to-center distance between their holes, along the tank. Note the diameter of each hole too. If the tank is held by straps instead of brackets, measure the spacing between them.
5. Confirm the gauge and take photos
If you know the steel gauge, include it; if not, measure the thickness with a caliper at the edge of a coupling. The steel gauge guide lists the equivalent in inches and millimeters. Then take these photos:
- The whole tank, from the side, with the tape measure extended next to it.
- Each head, straight on.
- A close-up of the couplings and brackets.
- The label or part number, if it has one.
Checklist for your order
- Overall length, in inches or millimeters.
- Diameter.
- Number, size and position of the couplings.
- Number and spacing of the brackets.
- Gauge, if you know it.
- Quantity.
- Photos.
With the length and diameter you can see your tank to scale and its volume in the quote tool, and send us the result on WhatsApp along with the photos.
